General Forums > Wooden Bombardiers
ORIN'S 50 REBUILD !!!!
orin:
Sorry for the late reply, been away fishing. The brass bushing seems like it will work alright. Will try to take some measurements for you in the morning O.T. The thing is, if i'm off a little, it's going to screw you up alot because the 300 fits so tight.
orin:
http://i966.photobucket.com/albums/ae141/orinleecarlson/Orinstransmissionwithinstructions.jpg
it lines up perfect with these bolts O.T. Mine is actually about an inch ahead of them, but if you put your even, you won't have to move your firewall ahead like I did.
the old trucker:
Thanks Orin!! That makes everything a lot easier. I still have the stump of the angle iron on the frame. Can you tell me if the metal used on the sides of the motor is welded or bolted to this angle iron??
I appreciate this info!! ;D
OT.
orin:
Its bolted, the same bolt goes threw the angle iron then the plywood and then the steel. The steel is just welded along the bottom to the frame.
the old trucker:
--- Quote from: orin on December 10, 2009, 10:55:24 pm ---Sorry for the late reply, been away fishing. The brass bushing seems like it will work alright. Will try to take some measurements for you in the morning O.T. The thing is, if i'm off a little, it's going to screw you up alot because the 300 fits so tight.
--- End quote ---
Orin I don't think that will hurt me for now. I can put the 3" channel in place & let the motor mount legs sit in place on top of it for now, allowing me to fine tune everything before bolting it in.
OT.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version