Performance Forums > Drivetrain

51 narrow woodie body shaft and axel shaft bearings and seals

(1/2) > >>

jerry7063:

  jerry here again looking for more help! while I was replacing the rear end axel seals I decided to look at the body needle bearings and seals and the boogie wheel bearings and seals! didn't like what I found!I appreciated the part numbers for the axel seals and now have my local parts man looking for them. now I need your help again anybody have part numbers for the needle bearings and seals on the body shafts and the roller bearings and seals on the boogie wheel shafts??I really appreciate all your help! I'm dieing to get this thing together and out on the lake,went fishing last week 30 below 0,way to cold to be riding a snowsled out to the fishhouse!!!

 Thanks again,
 
 Jerry

Averyman:
Inner wheel Brgs - Cup 15250 - Cone 15112
Outer                - Cup 09074 - Cone 09196
Wheel Seal 13865
These are SKF #'s through NAPA

I have no info on the needle Brgs

the old trucker:

--- Quote from: jerry7063 on January 03, 2010, 11:04:04 pm ---
  Jerry here again looking for more help! while I was replacing the rear end axle seals I decided to look at the body needle bearings and seals and the boogie wheel bearings and seals! didn't like what I found!I appreciated the part numbers for the axle seals and now have my local parts man looking for them. now I need your help again anybody have part numbers for the needle bearings and seals on the body shafts and the roller bearings and seals on the boogie wheel shafts??
 Thanks again,
 
 Jerry

--- End quote ---
     Did you call Shavers in Stonewall?? Jerry I think those 4" long needle bearings are like a piece of 1/4" cold roll. Mine are pretty good except for the 2 sleeves that hold them in place. I may have to see Shavers for new brass bushings if I can't pick up some localy. Some of the cup washers that hold the needles in the boggie on mine are almost worn through. I had a few 50 thousand shims cut to put inside. Also if you go to a truck parts store, ask them for shims for the king pins.The ones I got were 2" ID & 3" OD. You can get them 10 thou & up. They fit perfectly. I think I have the numbers for the boggie wheel somewhere in my emails. I'll have a look.

oldsledz:
Jerry,

 Contact Dan Shavers.  He has bronze bushings and you can replace all the needles and shims and put these in.  The work real nice.

Oldsledz

the old trucker:

  There you go, my friend. Dan Shaver will know the numbers for the bearings also. His phone number is on here somewhere.

Navigation

[0] Message Index

[#] Next page